I’ve always been a big fan of the Motion Sensor Light, the little plastic device that lights up whenever I push a button on my phone, but I’ve never really taken the time to figure out how to use it.
I was recently frustrated enough with the lack of a tutorial on how to set it up on my iPhone that I decided to do something about it.
To do so, I figured I’d do a little homework and learn how to turn it on and off.
I had to learn a little bit about the hardware first, so I got my iPhone and an iPhone 6 Plus.
I bought a small amount of batteries, so that I could keep the lights on.
The iPhone 6S Plus and 6S also have built-in LEDs, but the ones in the iPhone 6 are not compatible with the MotionSensor Light.
This means I can’t use them on my Samsung Galaxy S6 or S6 Edge.
The other thing I can do with the lights is turn them on and turn them off when I’m using them.
My setup for the Motion sensor lights works like this: Turn the light on, then hold it on for a minute or two.
When you turn it off, the LEDs go out.
Press the power button to turn the lights off.
You can also turn them back on and use them again later.
I usually just turn the light off and put it away, but this may be a good idea if you’re a frequent user of the lights and need to turn them more often.
The next step is to connect it to the MotionLight.
If you’re new to using the Motion sensors, it’s really easy.
This is a picture of the front and back of the motion sensor.
Now, this is where things get a little tricky.
There are three different directions in which the sensor can move: Normal: This is the motion light is off, but there’s no light on.
This can be a bad thing if you have a sensitive ear or nose, or if you are wearing a mask or headphones.
If the sensor is turned on, it will keep on turning even if the light isn’t off.
But if you turn the sensor off, you will turn the LED off.
This is dangerous, because it means that the sensor will turn on at any time, even if you don’t press a button.
Slightly Off: The sensor is off and you can’t see it.
You have to press the power and volume buttons to turn on the lights.
And that’s it!
You can use it all night without needing to turn your phone off.
It also works with the Apple Watch.
It’s really not that hard to figure it out, but it’s also really annoying when you have to turn off the lights at a moment in time.
To be honest, the only thing I really wanted to know was if it would work with the iPhone.
I’ve been using the Apple TV, but that doesn’t have any motion sensors.
I didn’t want to make the same mistake I did with the Samsung Galaxy Note 5.
I thought it was going to be great because I could use the motion sensors all night.
Instead, I ended up with a light that worked well only for my Samsung phone.
If you want to learn how the Motion Sensors work, check out this tutorial from the makers of the Samsung Motion Sensor.
You should definitely check it out.